Hefei Growking Optoelectronic Technology Co.,Ltd
Home /

Color sorter

/

CCD color sorter installation

CCD color sorter installation

2020-Nov-26

1. Installation precautions
  ① This ccd color sorter should be installed on a level ground, without pre-embedded anchor bolts.
  ②. The ccd color sorter machine should be installed in a separate isolated room (air conditioning is recommended), and should not be installed in low temperature, high temperature, humidity, and dusty places.
  ③. There should be no ground vibration at the installation site.
  ④. The machine must be installed in the last selection process, that is, after polishing or fine grinding.
  ⑤. Prevent strong electromagnetic interference on site and nearby. Therefore, the user's self-connected inlet and outlet pipes and exhaust pipes must use iron pipes, not plastic pipes and other non-metallic pipes, and have good grounding.

2, unpacking and inspection
After receiving the machine, be careful when unpacking to avoid unnecessary damage to the machine parts, and check the integrity of the parts and equipment.

3, mechanical installation
The industrial ccd color sorter should be installed on a sturdy platform with railings or on a hard ground (the platform is above 1.6 meters from the ground), and the level should be found and the level of the machine should be adjusted to 2/1000mm or less with a level. There should be a passage around the machine for operation, inspection and maintenance. According to the specific conditions of the site, the upper feed port corresponds to the user's feed pipe, and the pipe should be equipped with a flow adjustment plate and a storage box. Note that the feed pipe must not be pressed on the machine's feed hopper, otherwise the processing capacity will be affected.

   
Have a question? You can call us or email us by sending a message below.